How to Replace the Drive Belts on a Troy-Bilt Pony Lawn Tractor
This article will walk you through the process of removing and replacing the drive belts in a Troy-Bilt Pony lawn tractor.
How to Winterize Your Lawn Tractor
This maintenance guide will help teach you the steps and methods of winterizing a lawn tractor.
How to Do a Spring Tune Up on a Lawn Tractor
This article will serve as a maintenance guide for most common lawn tractors. Learn how to sharpen the blade, change the oil, change the fuel filter and replace your spark plug by following the steps...
How to Test a Small Engine for Spark
If your small engine isn't starting, you'll need to diagnose many issues including the spark plug. This video walks you through the steps of how to test for a spark using a spark tester.
Discussion for the Husqvarna YTH 2448 (96015000100) (2005-03) Ride Mower
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Husqvarna 48" Lawn Tractor.
I have a husqvarna 48" lawn tractor. Everytime I engage the blades the battery discharges, when I stop the blades the battery starts charging again. Also there is something draining the battery, I have unhooked the lights. Just at a loss here any help please.
Reply: Husqvarna 48" Lawn Tractor.
Hi 1299591 Well sir, according to a mechanic who does electrical diagnosis on another forum; here is what he said, as I am unaware of this problem:
"If your electric clutch coil is beginning to fail it will draw too much current and will drain the battery faster than the charging system can keep up with it. Apparently these electric clutch coils can begin to short between the windings. The clutch still works but the coil is drawing more current. At some point the current draw is more than the alternator can keep up with. Also as the clutch coil continues to fail the clutch will itself stop working."
Question: My YTH 2448 Dies
Every time i lower my deck ,my mower dies ,it has a new (blade control)clutch the blades turn freely when not engaged ,I've taken the deck off and turned it over to see if any thing was stuck.
This weekend I put in fresh gas ,a new gas filter.And went to start it and and now i have a stuck open valve.
Question: Husqvarna YTH 2448 Spindle Insta...
I am needing to install the spindle and I am confused on how to do it. The spindle is not threaded but the bolts are and not nuts.
Are the bolts self tappings.
thanks for all and any help
Reply: Husqvarna YTH 2448 Spindle Insta...
You will probably break the old bolts trying to get them to self tap.
I thread the housing with a tap the same size as the bolts and it is an easy
installation from there on.