We sell only genuine Tanaka ® parts.
Enter Your Model Number
Tanaka Replacement Parts by Category
Bicycle Engine Parts
Cut Off Saw Parts
Gas Drill Parts
Genuine Hitachi replacement part, this item is sold individually.
This handle is used to change the cutting degree of the Miter Saw Table and Head Assembly. So you can cut any angle of whatever material you are using.
To move the Table and Head, loosen the Handle, to secure the desired position tighten the handle.
Genuine Tanaka replacement part, this item is sold individually.
This Fuel Pipe Assembly connects to the fuel filter inside of the fuel tank.
It is then connected to the carburetor to feed it with fuel.
Genuine Hitachi replacement part,this item is sold individually.
This Fuel Line is the line that connects to the fuel filter inside the fuel tank.
It delivers the fuel to the carburetor by pumping the primer bulb.
If you want to replace the Fuel Tank Grommet , it will have to be ordered individually, it is part number 6685308.
This is a genuine OEM replacement part designed for Hitachi power equipment. The purpose of fuel line is to to return excess fuel back on the system. By pressing the primmer bulb it will fill the carburetor with fuel, once it is full the excess fuel will be forced back into the tank through the fuel return line. It is made out of plastic and it is sold individually.
Over time the fuel lines will deteriorate and become brittle so they would need to be replaced.
Genuine OEM replacement part, this item is sold individually.
The Return Grommet is inserted in to the fuel tank on the outdoor products shown below.
The the Return Fuel is installed into the Grommet.
Its purpose is to create a seal and prevent fuel leaks.
It may be easier to place the return fuel line in the grommet and install both in the fuel tank at the same time.