
We sell only genuine Wilton ® parts.
Enter Your Model Number
Popular Categories
Wilton Replacement Parts by Category
Commonly Purchased Parts
Popular Parts
This is an Genuine Manufacturer Authorized replacement part used on variety of power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.
This is an Original Manufacturer Sourced replacement part for a Drill Press. This is a Metal Spring and a Metal Cap/Cover that are a part of mechanism that Adjusts the Drill Height. If the adjusting Wheel/Knob Does not retract the spring may be damaged and should be replaced.
This is an OEM Authorized replacement part used on variety of power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.
This is an authentic replacement wheel tire for Wilton and Jet band saws. It is supplied directly from original equipment manufacturer and it is sold individually. Its purpose is to provide a stable grip for the saw blade. When attaching the new tire on a band saw wheel, it may appear too be too small, however it really is not. These tires when new are typically approximately two (2) or more inches shorter than the old tire. Tires are supposed to fit very tightly against the bad saw wheel. As the tire ages, the rubber hardens allowing for the blade to slip.
Note, it is a good idea to put the new tire in hot/warm water to heat it up just enough to make it pliable enough to stretch. Its advised to have two people in the stretching process.
This is a Genuine Manufacturer Approved replacement part designed for Bandsaws. This is an important part of Blade Guides. This part is made out of Metal and it is Sold Individually. Replacing this item you would need a set of Wrenches.