How much do you tighten the unloader? Will it affect the pressure you will get ?

My pressure washer has good pressure but when I let go of the trigger the motor acts like it is bogging down like the pump is building pressure. Could it be the relief valve? Any help is greatly appreciated.

my model 020241 has a leak under the top part of the manifold. what kit do i need to fix this?

I have a water leak coming from the seam on the handle. I replaced the o-rings for the nozzle and took apart the handle, where I found what seems like hard rubber seals and o-rings in both ends of the brass tube. Could this be my leak source? And if so, is there a repair kit available?----Thanks -------Walt

Water is coming out of the chemical inlet valve on the top of the pump when the water source is turned on, any suggestions?

I've got a Troy-Bilt pressure washer that worked great one day, and won't pump much more than a garden hose the next. I am sort of assuming that the check valves are bad. They look a little ragged where the seat is. Is this where my pressure is going? The motor is pulling just like it is pumping as usual, but I don't have much pressure at the nozzle.

I drained my pump oil and I need to know how much to put back in. I also need to know if regular pressure washer pump oil I purchased at Sears will suffice in my Honda 5.0 engine.

I have a broken brass pressure nozzle. What is the part number to replace it? I loaned the washer out and got it back with a broken nozzle. I really would like to have it running before spring.