This is a Genuine OEM Sourced replacement outlet kit designed for Pressure Washers. This is an Aluminum Outlet Extension with a Rubber O-Ring that connects between the pressure washer pump and the pressure washer hose. This Fitting is Sold Individually. To replace this item you would need a Wrench.

Genuine Briggs and Stratton replacement kit.
The purpose of the Fuel Valve, is to let you shut off or allow the fuel flow to the gas engine.
The Bushing is pressed into the hole provided in the fuel tank.
Then the Fuel Valve is pressed through the bushing so it is inside of the fuel tank.

Genuine OEM replacement part, this item is sold in a kit.
This is the part of the pressure sprayer that threads into the pump(First in, Spring then the Ball).
The the chemical hose kit connects to it.
Then the chemical hose kit is placed in the material (soap) that you want to use to clean the surface you want.

Genuine OEM replacement part, this item is sold individually.
This hose is used on over 150 Briggs and Stratton and Troy-Bilt Pressure Washers.
This is the Hose that connects to the Pump and Spray Gun.
It is 1/4" x 25' in length.

This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside the pump. Once the water gets to a certain temperature the thermal valve will open and release the pressurized hot water, to protect the pump. If this happens too often you have a greater chance of damaging your pump. This valve consists of one (1) metal and one (1) plastic piece. To complete this repair you will need a wrench.

This is an Original Manufacturer Approved O-ring kit designed for pressure washers. This kit replaces worn or damaged O-rings for the gun, hose and wand. The kit includes a garden hose filter. Overtime rubber rings tend to dry out and crack and should be replaced if they show signs of wear.