Repair Parts Home Power Tool Parts Bostitch Parts Bostitch Nailer Parts
Bostitch BT1855 Oil-Free Brad Nailer Parts
How to Install an Overhaul Kit in a Porter Cable Nail Gun
This article will teach you to install an overhaul kit in a Porter Cable nail gun, an important repair for anyone with a nail gun leaking air from the nose, head or trigger.
How to Install a Driver Maintenance Kit on a Porter Cable Nail Gun
This article will teach you to remove the piston and driver assembly from a nail gun, allowing you to replace a broken driver or access other parts that may be reducing your nail gun's performance.
How to Diagnose Power Air Nailers
This article discusses the common problems that air nailers encounter. It offers steps for troubleshooting each symptom and guidelines for repair.
Drilling, Fastening, and Hammering Power Tools
This article lists the major categories of drilling, fastening, and hammering tools, and explains the basic applications, types, and features of each.
Discussion for the Bostitch BT1855 Oil-Free Brad Nailer
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Ring, Piston And Piston Driver
the piston driver i am replacing has the ring, piston attached. I was under impression that the piston driver i ordered would have the ring attached. so much for assuming. anyway, can i remove the original ring and place it on the new piston driver? thanks
Reply: Ring, Piston And Piston Driver
I believe that uses a teflon ring in a plastic cylinder and as long as the cylinder and ring look good it should be fine.Be sure not to put grease or oil around the ring as if I remember right that tool is an oil free tool and any oil that gets around that ring or cylinder will attract dust and will act like a lapping compound prematurely wearing the cylinder and ring out. Hope that helps.good luck.