The Milwaukee 0234 corded drill has a unique brush holder. Both brushes are held in place with a spring-loaded holder secured to one side of the drill. This article will help you change the brushes on the 0234 corded drill.

Remember to use our Milwaukee parts finder to find brushes and other parts for your Milwaukee tools.  

Replacing the Brushes

1. Remove the brushes

Remove the brush-holder screw.

Use pliers to remove the holder from the drill--it's normal for the brushes to fall into the drill housing.

Flip the drill over and let the brushes fall out.

2. Install the new brushes

Slide the brushes into the holder and use your fingers to prevent them from popping out. 

Use your pliers to continue securing the brushes, then slip the assembly back into the drill.

Tighten the screw to finalize the repair.

[Back to Top]
 

Conclusion

And that's how you replace the brushes in a Milwaukee 0234 corded drill. This incredibly simple repair will only take about five minutes.

You can use our power tool parts finder to find all the right parts for your Milwaukee and other power tools.

[Back to Top]

What We're About