It is a genuine OEM sourced screw, it is not an aftermarket imitation. This high quality hardware is specially designed for use with Ridgid and Ryobi drills and drivers. It is generally used to secure the drill chuck. Includes (1) torx screw per order.

Genuine Manufacturer Approved replacement part used on a variety of Power Tools. This Ball Bearing has multiple applications depending on your tool. This part is made out of Metal and it is Sold Individually. Ball Bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

To replace this Bearing you would need a Screwdriver and a Set of Wrenches.

This genuine OEM sourced replacement ball bearing is a standard item which has multiple uses on a variety of power tools. Please check diagrams for proper application of this item. The bearing is specially designed to reduce friction between rotating parts. Over time it will wear out, at this point it should be replaced. This is a sealed metal bearing and it is sold individually.

Genuine Ridgid replacement part, this item is sold individually.
2 of these Brushes are needed for a set.
This Brush includes the Brush, Brush Holder, Brush Spring and plug in terminal.
It is always best to replace both brushes, even if only one is worn.

Worn brushes frequently are the cause behind a motor running poorly.
Replacing brushes can fix a motor that’s operating intermittently.
New brushes can restore a motor’s electric braking.

Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This replacement carbon brush is a genuine OEM sourced replacement part designed for use with a variety of power tools. This assembly includes one (1) carbon brush with a lead wire and a spring attached.

Carbon brushes are a commonly replaced part on power tools. Due to normal use and friction brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type.

You would need a screwdriver to complete this job.

• Make sure the unit is unplugged
• First remove the brush caps
• Take our old brushes and replace them with the new ones
• Secure brush caps and test the tool

This is an OEM Authorized replacement part used on variety of power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.