Motorsport Parts

This is a manufacturer approved replacement part used on Kawasaki engines. The push rod rides on the camshaft to push the exhaust valve open during the exhaust stroke. A bent push rod can not only affect your engine\\\'s performance, it can seriously damage other parts if the problem is not taken care of immediately. This part is made out of metal and it is sold individually.

It is an OEM item which is made for use with Kawasaki engines commonly installed on lawn and garden equipment. This gasket provides an air-tight seal between the case-rocker and the cylinder head. Over time the material will wear out and it may begin to crack eventually requiring a replacement to ensure engines proper performance. To ensure the correct installation of the new part, refer to the specific diagrams of your model. It is a high-quality gasket which is made of durable composite material and is sold as an individual component. You will need a wrench to remove and resecure the hardware that holds the cylinder head.

It is a genuine item that is supplied by the original manufacturer for use with Honda engines commonly installed on a variety of lawn and garden equipment. This is one of the flange nuts that are utilized to secure the exhaust manifold. A flange nut is designed to provide a tight fit and resist loosening. Replacing it is a simple task that should only require a wrench to remove and secure it. To ensure the correct location, please refer to the diagrams of your model. One durable metal nut-flange is included.

This is a genuine Power Wheels replacement part, it is sold individually.
The purpose of the Cap Nut is to secure the wheels on the models shown below.
When removing this part it usually will be damaged in the process.
It is advisable to order a few extra to keep on hand.

This is a genuine manufacturer approved replacement part designed for use with Power Wheels battery powered vehicles. This wheel connects to the gearbox and drives the unit. It is made out of plastic and it is sold individually. To complete this repair you would need a wrench.