This genuine OEM supplied part is specially made for use with Hoover vacuums. The purpose of the belt is to drive the brush roller assembly. It is installed on the shaft of the motor and on the end of the brush roller. It provides an identical replacement for a missing or a faulty component that was installed on a new unit. Please make sure to check the owners manual and the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality belt is made of durable rubber and is sold individually.

NOTE: We do have an article and a video on how to install this belt. Here is the link to it.
How to Replace a Vacuum Belt

This is a genuine OEM replacement part, this part is sold individually.
The purpose of this bag is to hold the dirt and debris the model numbers below pick up.
The bags are also available in a 7 pack, that part number is 401000BP.

This is an OEM sourced replacement part designed for use with Hoover vacuums. This filter helps to keep the air clean. This part is made out of plastic with paper filter material and it is sold individually.

No tools are required to replace this Filter. You can simply remove the old filter from the vacuum cleaner and replace it with the new one.

Designed according to strict HEPA standards, the media in this filter trap particles 75 times smaller than a human hair, including 99.97% of dust mite debris, animal dander, molds and pollen down to 0.3 microns.

This is a genuine OEM pre-filter designed for use with Hoover upright vacuums. This filter is located inside of the top of the dirt cup. Open it to expose the primary filter. Pull the tab on the filter to remove it from the dirt cup. Hold filter under running water for two minutes to remove dirt and debris. Allow filter to dry completely before replacing. Replace new filter, tab side out. Filters should be cleaned/change at least every two months under normal use.

This is a genuine OEM part sourced directly from Hoover. It is the translucent red part that sits inside the dirt cup housing, beneath the filter and filter cap. One baffle is included.

To Remove and Replace This Part:
• Hold dirt cup filter side up; press the release button to open the bottom door
• Twist the baffle tube counter clockwise until it stops
• Slide the baffle tube out; hold over trash can and shake clean
• Insert baffle tube into dirt cup with wide end facing towards bottom door; align slots and twist clockwise until it locks into place

Genuine OEM replacement part, this item is sold individually.
The purpose of this belt is to rotate the Brush Roll on the vacuum models shown below. This belt is Style 23.
Depending on the model you have, it can be installed in different ways.
If possible look how the old belt was installed so it will be easier to replace it.