Detent Spring

Genuine OEM replacement part, this item is sold individually.
This spring is used in various locations of the tools listed below.
Over time springs will loose their tension and will need to be replaced.
The dimensions on this spring are 5/16 in length and 3/16 in diameter.

Cord Protector

This cord protector is a genuine DeWalt replacement part and is sold individually.
Cord Protectors are designed to slide onto your cord and fit securely at the end, where it’s firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

Carbon Brush

Genuine Dewalt/Black & Decker replacement part.
includes 1 Carbon Brush with wire lead and brush spring attached.
2 Brushes are needed for the tools listed below.

• Worn brushes are often the cause of a poorly running motor
• Replacing brushes can fix an intermittent motor
• New brushes can restore a motor’s electric braking

Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Ball Bearing

This is a genuine OEM replacement part, it is sold individually.
This Ball Bearing is sealed on both sides.

Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction.

This reduces wear on the tool and allows it to run smoothly.

Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Handle Assembly

This is a genuine Delta crank handle which is found on many drill press models. It will directly replace a worn, broken or missing handle. Please note that this handle does not include the set screw for securing it in place. The handle will fit the Delta drill press models listed in the section below, but it is not guaranteed to fit any other tools.

Switch

This Rocker switch has 4 terminals and a compact design for easy installation. This authentic Delta replacement part is sold individually.

Switches are commonly replaced parts in power tools, handling all on/off and variable speed operations. They also have a role in electric breaking; they can momentarily reverse electrical polarity. Because switches use mechanical internals, they will degrade and wear out over time, eventually requiring replacement. Some common signs of a broken or failing switch are:

The tool will not start when you use the switch, or it requires multiple tries to turn on, until eventually it refuses to start at all.

The variable speed function and electric braking aren’t working properly.