Repair Parts Home Power Tool Parts Milwaukee Parts Milwaukee Electric Drill Parts
Milwaukee 0375-1 (SER 611A) DI 3/8" Angle Drill Parts
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
How to Remove a Stuck Drill Chuck
Broken gearboxes and sticky chuck screws can make removing a drill chuck difficult. This article explains the tricks you need to overcome these common repair setbacks.
Drilling, Fastening, and Hammering Power Tools
This article lists the major categories of drilling, fastening, and hammering tools, and explains the basic applications, types, and features of each.
How to Remove a Drill Chuck
This article explains steps for how to remove threaded-on chucks and taper-fit drill chucks, as well as steps for removing a spindle from an open-center chuck.
Discussion for the Milwaukee 0375-1 (SER 611A) DI 3/8" Angle Drill
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Milwaukee 0375-1 Gear And Pinion...
Anyone know what I need to do to replace these parts? If I need a bearing puller etc. or does it come off from the chuck side?
Reply: Milwaukee 0375-1 Gear And Pinion...
The bearings and gear are pressed on. They press on from the side opposite the chuck. To make the repair you will first need to remove the chuck.
The following link will help with that...
Replacing a drill chuck.
Now you can open the housings and remove the spindle. The best way to remove the bearings and gear will be with a bearing press. The new bearings and gear can then be pressed back in place.
I hope this helps!
Accessories for the 0375-1