Repair Parts Home Power Tool Parts Black and Decker Parts Black and Decker Jigsaw Parts
Black and Decker JS660 Type 1 Jigsaw Parts
How to Diagnose a Bad Power Cord or Switch
This article outlines the basics of power tool and appliance electrical diagnosis. You can use a multimeter to test tool and appliance cords and switches, the two parts usually responsible for electri...
Power Tool Care and Maintenance 101
This article suggests guidelines for power tool care and maintenance. It also describes information tools available at eReplacementParts.com.
Time Spent Repairing:
Entry Date:2013-10-25 11:27:22
0 of 0 customers found these instructions helpful
Unscrew Hex screws on front of blade clamp. Lightly tap blade clamp down using hammer and small screwdriver. Take blade clamp out by way of front of saw. Place new blade clamp in position. Lightly tap blade clamp into position. Screw hex screws back to hold clamp. Done
Discussion for the Black And Decker JS660 Type 1 Jigsaw
Post a Comment
Ask a question, answer a question, or post a comment!
Question: Blade Support
How long is this going to take to get? Does it have to be made? Is the factory out of this item?
Reply: Blade Support
The part number 90517418SV blade support has been discontinued by the manufacture, without a replacement part number.
Is there some trick to getting the housing apart? I've got all the fasteners off, but it still seems to be stuck together. I don't want to pry too hard if I'm missing something. Thanks!
Pete Doughty-Maint Dept-Marine Electrical Products
Place tool with screw heads up.....remove all the screws....REMOVE the silver plastic trim piece, there are 3 more screws hidden under that...slowly lift the top piece up while holding the lower half down. That's the way I just did it :)
I'm wondering why there is no part number for the brushes.
Accessories for the JS660