Genuine Ryobi replacement part.
rnIncludes 1 Carbon Brush with wire lead, braket and brush spring attached.rn

• Worn brushes frequently are the cause behind a motor running poorly.
• Replacing brushes can fix a motor that’s operating intermittently.
• New brushes can restore a motor’s electric braking.

Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Genuine OEM Replacement Part used on some Ridgid Power Tools. This part is Sold Individually. Safety Kit is Sold Separately. A switch handles the on/off and variable speed functions. They also have a role in electric breaking; they can momentarily reverse electrical polarity. Because switches use mechanical internals, they will degrade and wear out over time, eventually requiring replacement. The Key is sold separately.

Genuine Ridgid replacement part, this part is sold individually.
This Switch Key is used on the Ridgid tools listed below._b_It must be used in conjunction with the Switch part numbers 826347 & 826123 or the switch will not function.
The Switch Key is inserted into the switch, then the switch will be operational.
This is safety feature for unauthorized use of the tool.

Genuine Ridgid replacement part, this item is sold individually.
There are three of these Blade use in the Ridgid Jointer/Planer Machines listed below.
These blades can be sharpened a few times, after that they become too short to be used in the jointer.
When you install the Blades you want to make sure they are the exact same height of the out feed table.
Make sure the cutterhead is at top dead center when you install them.
The Blades are spring loaded, so you can use a straight edge on the out feed table.
Bring it down on the blade then tighten the bolts.

This is an OEM Authorized replacement part used on variety of power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.