This is an Genuine Manufacturer Authorized replacement part used on variety of power tools. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is a Genuine Manufacturer Sourced replacement part used on certain Drill Presses. This Coil Spring Assembly is made out of metal and it includes the: Cap, Coil Spring and Spring Retainer Ring. This part plays an important role in the mechanism that allows to lift the Drill Bit up and down. By providing spring loaded tension this allows for the shaft to return to its original position.

This is a Manufacturer Approved replacement part used on some Jet Power Equipment. Elevation handle lets you raise and lower the quill. This part is made out of Plastic and Metal and it is Sold Individually.

This is an Original Manufacturer Sourced replacement part for a Drill Press. This is a Metal Spring and a Metal Cap/Cover that are a part of mechanism that Adjusts the Drill Height. If the adjusting Wheel/Knob Does not retract the spring may be damaged and should be replaced.

This is a genuine OEM sourced replacement part designed for use with Jet drill press. It allows height adjustment handle to retract. It is made out of metal and it is sold individually. You would need a wrench to complete this repair.