When teeth on a drill press adjusting rack break you can lose performance because the table won't adjust along its full range. This video outlines the steps necessary to replace the adjusting rack s...
Discussion for the Jet JDP-17MF (354169) 17 In. Drill Press
Discussion is closed. To ask our experts a question about a part, use the Q&A feature on our product pages.
Question: JDP-17MF Belt Slippage
Set on a pretty low speed, this machine's belts slip quite a bit. I'm not able to get enough tension with the tension adjuster. Any suggestions? maybe a different belt size or adding a 3rd belt?
Question: Table Bracket Assembly
Does table bracket assembly 10901203A1 include bracket 10700605a1 as shown in diagram part #12?
Question: Bracket Assy Part No. 10700605a1
what size column does it fit
The part number 10700605A1 Bracket Assembly will fit columns with a diameter of 3-1/8 inches.
Question: Quill Set Screw
Hi, I noticed I had movement in the shaft of the drill (Side to Side Movement) so we adjusted the Quil Set Screw and it seemed to have stopped the side to side movement, but now the handle is tight to turn we have even loosed it right off and still really tight to turn has something broken in there or can someone give me heads up on why this has happened and how to remove the Quill set screw to see in there?
Ok, I have a black bull brand drill press and the spindle was out of round, undersized and had a bad finish on it and was running out .011 of an inch. I was wanting to know if the spindle on this drill press would work for my drill press?
Question: Spindle Bearing Replacment
How do I replace the spindle bearings in my JDP-17MF?
How do I install the rack on my JDP-17MF
Question: Copper Windings
4 copper strands have burned in half. Can they be soldered back together? Also, the yellow lead #4 has come detached from the windings. Can that be repaired?