Why Read This Article?
Finish Nailer Repair - Replacing the Driver Guide (Ridgid Part # 79004001022)
Article Breakdown
Finish Nailer Repair - Replacing the Driver Guide (Ridgid Part # 79004001022)
Tools & Materials
- Screwdriver
Swing by our KitchenAid parts page to browse our huge selection of replacement parts. Removing the capacitor
1. Remove the bottom cover of the food processor
Use a screwdriver to remove the 4 screws on the bottom of the food processor, then remove the bottom cover.
2. Open the capacitor housing
Use a screwdriver to remove the 2 screws on the capacitor housing.
3. Remove the capacitor wires
Pull the wires off of the capacitor with a pair of needle-nose pliers.
4. Remove the capacitor
Remove the capacitor from the housing.
[Back to Top] Installing the capacitor
1. Install the new capacitor
Place the new capacitor into the capacitor housing.
2. Replace the wires
Install the wires onto the new capacitor in their original location.
3. Reinstall the housing cover
Use a screwdriver to fasten the housing cover with the two screws that were removed earlier.
4. Replace the bottom cover
Place the bottom cover back into position and secure it using the 4 screws.
[Back to Top]
Conclusion
By following this article step-by-step you should have no problem replacing the capacitor in your KitchenAid food processor. We make it easy to find the parts you need and help you get them installed.
Check out all of the KitchenAid food processor parts we offer here.
[Back to Top]
What We're About