This is a genuine OEM replacement part, it is sold individually.
The Fuel Filter is inside of the fuel tank.
Its purpose is to filter out dirt and other debris from contaminating the carburetor.

It will at sometime become clogged and restrict the fuel getting to the carburetor,and will have to be replaced.

We do have an article and video on How to Replace the Fuel Filters in Your Outdoor Power Equipment..

You can see this by going to the front page of our site and clicking on Repair Center.

Genuine Tanaka replacement part, this item is sold individually.
This Fuel Pipe Assembly connects to the fuel filter inside of the fuel tank.
It is then connected to the carburetor to feed it with fuel.

This is a genuine OEM replacement part designed for use with a variety of power tools/equipment. It is made out of rubber and it is sold individually. By pressing on the purge bulb, it will force fuel into the fuel line from the fuel tank into the carburetor. Once the carburetor is full of fuel, the excess fuel will be purged back into the tank in the fuel return line.

At some time the primer will lose its elasticity or crack and need to be replaced.

This is an OEM approved replacement part designed for gas trimmers/brush cutters. Its purpose is to filter out dust and debris from contaminating the carburetor and engine. When replacing the filter you can open the package in comes in and put a bit of two cycle oil in the bag and let it absorb into the filter. Then remove it from the bag and squeeze it with a paper towel to remove the excess oil.

To replace this filter no special tools are needed. Simply remove the cover and replace the filter element.

Genuine OEM replacement part, this item is sold individually.
The Return Grommet is inserted in to the fuel tank on the outdoor products shown below.
The the Return Fuel is installed into the Grommet.
Its purpose is to create a seal and prevent fuel leaks.
It may be easier to place the return fuel line in the grommet and install both in the fuel tank at the same time.

This is a genuine OEM sourced replacement part designed for use with grass trimmers/cutters. The purpose of the eyelet is to let the cutting line out of the spool assembly with out damaging the part of the housing the the eyelet is installed in.
It also allows the cutting line to exit the spool smoothly with out being cut. It is made out of metal and it is sold individually.

No tools are needed to replace this eyelet. Simply insert into the opening of the spool housing.