This is a genuine manufacturer-sourced part which is designed for use on lawn and garden equipment. It is an identical replacement for a missing or a damaged clamp that is used to secure the hose. Keep in mind this high-quality product is made of durable metal and is sold individually. Please make sure to check the appropriate diagrams for your model for the correct location and application of this hardware.

This is a genuine OEM sourced replacement part for Lawn and Garden equipment. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt. It will have different applications based on your equipment. Please refer to diagrams for proper use. This item is metal an is sold individually.

You would need a wrench to tighten/loosen this nut.

This is a genuine OEM replacement part used on a Murray lawn and garden equipment. This ball bearing has multiple applications based on your equipment. Bearings are generally used to reduce friction between rotating parts. Because bearings experience constant wear from pressure, heat, vibration and friction, they would need periodic maintenance or replacement. This part is made out of Metal and it is Sold Individually.

To replace this Bearing you would need a Screwdriver and Pliers.

This is a Genuine Manufacturer Sourced replacement part used on Lawn and Garden Equipment. This part is made out of Metal and it is Sold Individually. Ball Bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

To replace this Bearing you would need a Screwdriver and a Set of Wrenches.

This is a genuine OEM sourced replacement shear pin designed for use with snow blowers/throwers. Shear pins are installed in order to protect your snowblower and it measures 1/4 X 1.750. If the auger gets jammed or clogged, shear bolt is designed to snap at a certain point of pressure, so it will not damage any other part of the unit. This pin is made out of metal and it is sold individually. Please note the cotter pin used to secure this pin is sold separately. In order to install or remove this pin you will need pliers.

This is a Genuine OEM replacement part designed to work with a variety of Engines. This part is made out of Rubber and it is Sold Individually. If the carburetor is leaking fuel it is recommended to replace the Bowl Gasket. Gaskets and O-rings are a common source of problems. They eventually shrink, causing fuel and air leaks that lead to poor engine performance.