Genuine Manufacturer Approved replacement part used on a variety of Power Tools. This Ball Bearing has multiple applications depending on your tool. This part is made out of Metal and it is Sold Individually. Ball Bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

To replace this Bearing you would need a Screwdriver and a Set of Wrenches.

Genuine Ryobi replacement part, this item is sold individually.
The Plug in Lanyard is used to attach to your tool belt or belt loop, while the battery for the cordless tools below is being charged.

Genuine Ryobi replacement part, this item is sold individually.
The purpose of this Clamp Nut is to secure the Grinding wheel to the spindle of the Grinders shown below.
To tighten the nut to the spindle, you will need to depress the spindle lock assembly on top of the gear case.
Then use the part number 039028001052 Spanner Wrench to loosen and then tighten the nut back on.

This is a genuine Ryobi replacement part, and is sold individually.
Worn brushes are often the cause of a poorly running motor
• Replacing brushes can fix an intermittent motor
• New brushes can restore a motor’s electric braking

Carbon motor brushes are one of the most commonly replaced power tool components.
Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement.
Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power.
A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned.

When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Genuine Ryobi replacement part, this item is sold individually.
The purpose of the Brush Cap, is to secure the brushes and keep the brush tight against the armature in the housings of the tool models shown below.

Genuine Ryobi replacement part, this item is sold individually.
This Spanner Wrench is used to remove and tighten the 039028001001 Clamp Nut which holds the grinding wheel on the tools listed below.
While pressing the spindle lock on top on the gearcase, the it is placed in two of the holes of the Clamp Nut to loosen of tighten the nut.