This is genuine replacement carbon brush designed for use with Jancy metal cutters. This assembly includes one (1) carbon brush with a lead wire and a spring attached.

Carbon brushes are a commonly replaced part on power tools. Due to regular use and friction brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type.

You would need a screwdriver to complete this job.

• Make sure the unit is unplugged
• Remove screws from the motor housing
• Take off motor cover to gain access to the brushes
• Take out old brushes and replace them with the new ones
• Re-assemble and test the tool

This is an manufacturer sourced replacement brush set designed for use with Jancy drill press. This assembly includes two (2) plastic brush caps and two (2) carbon brushes with lead wires and springs attached. Please note brush holders are sold separately.

Due to prolonged contact with an armature brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type.

You would need a screwdriver to complete this job.

• Make sure the unit is unplugged
• Remove the brush cap and take out the old brush
• Secure the new brush with a cap and test the tool

This replacement part is designed for use with Jancy power equipment. This item consists of one (1) carbon brush with a lead wire and a spring attached. It is advised to replace both brushes at the same type. Over time brushes will wear down and will need to be replaced. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

You would need a flat-head screwdriver to complete this job.

• Remove the brush cap
• Remove old brush and replace it with a new one
• Re-assemble and test the equipment

This is a Jancy replacement part sourced directly from the manufacturer. The cermet insert for BM20 is constructed of 12 high-quality, metal, cutting inserts in a plastic case. This part is compatible with some portable bevelers, and is sold individually. Please refer to specific manual and diagrams for repair instructions.

This circuit board is supplied directly from the original equipment manufacturer. This Jancy component is constructed of intricate metal, wiring and plastic parts. It is compatible with several drilling machines. This part is secured between the cavity insulator and the switch assembly panel. The circuit board controls and supports the electronic signals within the drilling device. This part is sold individually. A screwdriver may be helpful in the replacement.