This is a genuine OEM part. The timerdefrost (60 hz ,120 v) is compatible with many refrigerator appliances. This item is secured to the defrost circuit in the freezer control housing. The timerdefrost manages the defrost heater, melting the excess ice from the coils. the timerdefrost is sold individually. A screwdriver is required for installation.
This is a genuine OEM part sourced directly from Frigidaire. This metal drip bowl was designed for use in electric ranges and is used to catch crumbs and other excess food that falls below the heating element while cooking. No tools are required to replace this part. Simply remove the surface element by pulling outward, set the new drip tray in place after removing the old one, and press the surface element back into place. One item is included per order.
This is an OEM replacement part for Frigidaire electric cooktops/ranges. This drip bowl is located underneath the heating element to collect spills or drips around the burner. To install and/or replace the drip bowl requires no tools. Simply remove the surface element first by pulling outward, remove the old drip bowl and set the new drip bowl in place and press the surface element back into place. This part is made of stainless steel and is sold individually.
This is a genuine manufacturer-sourced component which is specifically designed for Fridgidaire Dishwashers. The Gasket which is found on the bottom of the dishwasher door helps prevent water from leaking out the bottom. If you are expieriencing leaking this needs to be replaced. The gasket is made of a flexible rubber and is sold individually.
The Oven Bake Element is a black, metal part which supplies heat to the oven. This element is 19-1/2" wide x 18-1/2" long and has 3-1/2" inserts. It is rated as "Easy" to install by users, and attaches to the bottom of the oven. If you notice visible damage, or that your oven is not receiving heat properly then it may be a problem with this part. Check your model number and user manual to see if this is the right part for you. It is important for you to disconnect your appliance from the power source before performing this repair. After disconnecting your appliance, remove the two screws/nuts connecting the old element, pull it out, and discard if faulty. Simply connect the new element prongs where the old element fit, and screw it back in.