Why Read This Article?
Finish Nailer Repair - Replacing the Driver Guide (Ridgid Part # 79004001022)
Article Breakdown
Finish Nailer Repair - Replacing the Driver Guide (Ridgid Part # 79004001022)
Tools & Materials
- Phillips-head screwdriver
Remember to use our DeWalt parts finder to find belts and other parts for your DeWalt tools.
Replacing the Belt
1. Remove the belt cover
Remove the screw that secures the belt cover, then remove the belt cover.
2. Remove the belt
To remove the belt, pull out on it as you rotate it around both pulleys. This can take a few minutes, but it should slowly work its way off the pulleys.
3. Install the new belt
Wrap the belt around the edge of one pulley. Then wrap it around the second pulley and push in on it as you rotate it around the pulleys.
4. Replace the belt cover
Replace the belt cover and tighten the screw to finalize the repair.
[Back to Top]
Conclusion
Replacing the belt on your DeWalt miter saw is an easy repair. In about five minutes you'll have your saw running like new again.
You can use our power tool parts finder to find parts for all your power tools.
[Back to Top]
What We're About