This piston ring is an authentic manufacturer approved replacement part. Is is commonly used on Echo gas trimmers/edgers. The purpose of a piston ring is to create an air tight seal inside the cylinder. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase. This would cause low compression and a loss of power. Replacing an o-ring should resolve this issue. This part is made out of metal and is sold individually.
To complete this repair you will need a set of wrenches, pliers and a screwdriver.
• Remove the air cleaner • Drain the fuel • Remove the air cleaner case • Remove the carburetor • Remove the intake insulator • Remove the spark plug • Remove the engine cover • Remove the insulator gasket • Remove the starter assembly • Remove the fuel tank • Remove the air duct • Separate the engine • Bind the engine • Remove the clutch • Remove the flywheel • Remove the starter pulley • Unbind the engine • Remove the muffler • Separate the cylinder from the crankcase • Remove the piston ring • Install the piston ring • Reassemble and test the equipment
It is a genuine item that is supplied by the original manufacturer for use with Echo and Little Wonder handheld lawn and garden equipment. The purpose of this clip is to secure the vent pipe to the fuel tank vent. It provides an identical replacement for a faulty or a missing hardware that was installed on a new unit, please make sure to check the diagrams of your specific model for the exact location and application of this component. Keep in mind this high-quality clip is made of durable metal and is sold individually.
This is an authentic OEM sourced item that is specially produced for use with Echo manual sprayers. It is a replacement seal for the cap assembly, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. Over time the material may wear out and begin to crack eventually requiring a replacement, keep in mind this high-quality rubber seal is sold individually.
This is an original replacement part manufactured for use with outdoor power equipment. The special e-ring is commonly used to secure the plastic starter pawls to the starter pawl assembly. This e-ring is sold as an individual replacement part, please see model diagram for associative parts.
This is an authentic replacement part manufactured for use with outdoor power equipment. The special Snap Ring is commonly used to secure the piston pin to the piston. This snap ring is sold individually, please note two snap rings are required.
This is an authentic OEM sourced component which is specially designed for Echo backpack blowers. The purpose of a ring is to provide a tight seal between the piston and the walls of the cylinder, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase, causing low compression and a loss of power. If compression is reduced significantly, the engine will not run at all. Keep in mind this high-quality piston ring is made of durable metal and is sold individually.
This is a genuine replacement part sourced directly from the manufacturer. The O-ring is commonly found in Echo yard tools such as trimmers, chainsaws, and edgers. This part is made of flexible rubber, and may be found in various locations in the machine, depending on model. Please refer to the parts diagram to be sure of ordering the correct part. You may require a screwdriver or wrench when replacing this item. The O-ring is sold as an individual replacement part.
This is an original Echo replacement part. The spray fan tip is designed by the manufacturer for use in manual sprayers. This part contains three optional spray wand tips made of high-quality plastic, which can be attached to the end of the spray wand to create different spray patterns. No tools are required when replacing these items. Simply remove the old part and slot the new one into place.