Pedal Arm Sleeve

Loosened bolt and removed old sleeve. Replaced with new sleeve and tightened.

Replaced sleeve & cover and it is working very well. I do need to order some additional parts as soon as I do an overall check to see if additional parts are worn/needed.

Removed the retaining bolt, the cap and the bushing. Replaced with the new parts.

My son had it fixed when I got home, however I was planning on doing it myself. Just remove the old arm sleeve, replace with the new one and apply the new large axle cover and tighten with allen wrench. It was a no brainer. I was impressed with the ease of ordering, the low shipping price and the fact that ereplacement parts had the exact book for my elliptical from Nordic track. I knew exactly the parts that I needed. I tried ordering on line and on the phone with the Nordic track company and it was a huge fiasco. My credit card wouldn't go through and I couldn't get anyone on the phone! Plus they were going to rake me over the coals with the shipping price! Thanks so much, because I need my elliptical!

1. Use Allen wrench to remove the bolt holding the broken axle sleeve and cover.
2. Use a screwdriver to push out bearings from the old axle sleeve. You may be able just to use a finger to pull them out.
3. Put the usable original bearings in new axle sleeve then put on the axle.
4. Place large axle cover over axle sleeve and secure it with the Allen bolt and wrench.
5. Repeat for other side.

Removed rear cover
Removed broken sleeve with allen wrench
Slid broken part off
Installed new part and returned cover to original location
15 minute repair
Easy company to work with and I'll buy again from here.

Removed old bushing and replaced

Removed old parts and put new on. Allen wrench only tool needed.

Removed old part, put new one on. Fairly simple.

Took off the old arm sleeve and put the bushings in the new arm.