Carburetor Gasket

I removed the air filter, then the two screw that hold the carburetor, removed the carburetor, then the old gasket and cleaned the area. Installed the new gasket and assembled the rest in reverse order, Runs great now.

Remove the air box cover. Then remove the throttle and fuel lines from the old carburetor. Mark where the fuel lines went. Remove the screws holding the filter base and carburetor. and remove the carburetor gasket. Install the new gasket and carburetor with the filter base and screws. Attach the throttle and fuel lines. Then the air box cover.

Removed the fuel lines and throttle cable from the old carburetor. Remember where the fuel lines were on the carburetor. Then removed the screws holding the air box base and the old carburetor and removed the old gasket. Installed the gasket and new carburetor, then the air box base with the two screws. Installed the fuel lines and throttle cable.

Replaced carburetor. Marked fuel lines. Remove two screws .Took screws out. Remove old carburetor. Installed new carburetor and gasket. Connected fuel lines gas lines. Pulled the start rope, Started right up. Thanks.

Remove the complete air cleaner assembly and carburetor
Remove and clean the area where the gasket is
Install the screws through the airbox base, carburetor and new gasket and tighten
Install the rest of the air cleaner assembly

You start by removing the air cleaner assembly. Remove the fuel lines from the old carburetor and mark where they go. Remove the throttle assembly. Then remove the two screws securing the carburetor and gasket. Remove the old carburetor and gasket.. The install the new gasket and carburetor, and tighten down the screws. Replace the fuel lines and throttle. Then put the air cleaner assembly back on the unit. And your done.

This was a great little project that went well from the time I ordered and received the new carburetor & gasket.the trimmer when I tried to start it up started on the first pull.It had not done this Since I had purchase it 10 years ago.I was very happy about the whole project. I want to give a great thanks to EREPLACEMENTPARTS for there quick service processing my order,the product came well packaged and on time.Will use EREPLACEMENTPARTS for all my lawn replacement parts.thanks again EREPLACEMENTPARTS for your help on this project.You have a loyal customer for life.

I empty the gas tank.unscrewed the two screws holding the carburetor on cleaned off around the gasket mount.put the new gasket and carburetor on and I was off trimming the lawn 15-30 minutes later.

It was fairly easy to replace the carburetor , gasket and the throttle lever. You just use a socket and a wrench to unscrew a couple of nuts and take both fuel lines off and take old carburetor off and replace with new carburetor and gasket and pull off old throttle lever and replace with the new one. Thanks

Make note of choke knob position and fuel lines for reassembly. Remove fuel lines at carb and choke selector knob. Remove 2 carb mount bolts, one is a socket, the other a torx. Pull carb, position new washer by lining up holes and then reassemble in reverse order.

Took the carburetor off put new one on put the new tank on it ..hooked the cables on to carburetor and hoses to primer put gas in tank primed it up pulled cord a couple times and set the screw a little on cable to slow it down a bit and worked great after that..I would use from eReplacement next time for anything when need a part