Washer,​​ Flat

Remove and replace. Drilled then easy out threaded bolt

Disassembled, like replacing belts, removed remains of old bearing, cleaned up shaft at pulley area. Replaced defective parts and reassembled. Pretty straight forward after reading the manual. Used a tie down instead of a second person to pull auger section and power section together on re assembly. Could do it slowly and steadily while checking fit and clearance and it held sections together while I put the attachment bolts in the housing. All parts matched the originals with no problems and would use this website again .

Removed snow shoot, removed 2 bolts that hold the impeller onto the blower. The pulley bolt was sheared off . Removed broken stud in impeller shaft with a easy out. Replaced new pulley reassembled the auger assembly, and snow shoot works great. Didn't need any instructions all self explanatory.