Watch The
Repair Video
Repair Video
*This part replaces obsolete part #: 799248.
Product Information
Description:
| This is a genuine OEM sourced replacement carburetor designed for use with Briggs and Stratton engines. It mixes air and gas before the fuel mix goes in the engine. This kit includes a metal body carburetor, two composite material gaskets and an o-ring. You can test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. To complete this repair you would need a screwdriver. • Remove the rear cover • Remove the carburetor • Remove the fuel filter • Install the fuel filter • Install the carburetor • Re-assemble and test the unit |
Compatibility
This part is compatible with the following machines:
the 22 compatible machines
Questions & Answers
No questions have been asked yet
Repair Instructions: Submitted by Customers Like You
3 of 5 people found this instruction helpful
Tool Type:
Engine
Parts Used:
Repair Difficulty:
Easy
Time Spent Repairing:
Less than 15 minutes
Tools Used:
Socket set
Carb was leaking
Removed fuel line
Removed air box
Removed bolt that mount carb
Removed springs and linkage
Installed linkages to new carb
Installed new carb
Reinstalled removed parts
Removed air box
Removed bolt that mount carb
Removed springs and linkage
Installed linkages to new carb
Installed new carb
Reinstalled removed parts
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Tool Type:
Engine
Repair Difficulty:
Medium
Time Spent Repairing:
15-30 minutes
Tools Used:
Pliers, Socket set, Wrench Set
Motor not starting…
Motor would not start and after disassemble discovered that the carb was all gummed up due to bad gas. It was easier to replace carb, filter, and spark plug. Engine started right up after repairs.
Did you find this story helpful?
Thanks for voting and helping fellow customers!
Product Information
