Watch The
Repair Video

Brake Return Spring

Part Number: 932-0722A

Leaves our warehouse within
4 - 10 business days

Questions & Answers

Repair Instructions

*This part replaces obsolete part #: 732-0454, 732-0722 and 732-0722A.

Product Information

Manufacturer: Ryobi, MTD, Yard Machines, Bolens, Yard Man, Troy-Bilt, Husky

Product Number: 932-0722A

Classification: Part

Weight: 0.04 lbs.

Shipping: Ships Worldwide

Description:

This part is an OEM from Ryobi for use with Lawn Tractors. The brake return spring attaches to the brake lever to release the brake. The most common reason for replacing a brake return spring is when it is broken or worn out, which can cause the brakes to not disengage when the user stops pressing the brake pedal. This part is sold individually. The tools that you will need to replace the brake return spring is a floor jack, large flat-head screwdriver, and a flat-head screwdriver.

Warning: California's Proposition 65

Compatibility

This part is compatible with the following machines:

Ryobi

13AN688G034 Lawn Tractor

MTD

Expand the 150+ compatible machines

Products Compatibility

This item works with the following types of products:

• Lawn Tractor

Questions & Answers

Sort by

Mine came off. How do you put the two springs back together. Where or what do they attach to???

Steve asked on 2018-08-28

Hi Steve, Thank you for your question. First make sure your break is disengaged before beginning your repair. Remove the rear left wheel of your tractor by jacking the lawn tractor up with a floor jack. Remove the dust cap from the middle of the wheel and then pry the clip off so you can remove the parts holding the wheel on. Be sure to note the order these parts are installed in. This will actually reveal the break return spring for you. Remove it with a pair of pliers. Then install the new spring and follow these steps in reverse to install your wheel back on. I hope that helps. Good luck with your repair.

Did this question help you?

Repair Instructions: Submitted by Customers Like You

4 of 7 people found this instruction helpful

Tool Type:

Lawn Tractor

Parts Used:

Brake Return Spring - 932-0722A

Repair Difficulty:

Easy

Time Spent Repairing:

Less than 15 minutes

Tools Used:

, Small length of a nylon rope with a loop at one end

Tractor was missing a deck extension spring and the part that anchors the spring on the rear axle. The belt wasn't being tensioned right on the PTO without the parts!

The repair was easy once I received the missing part from eraplacementparts.com. It was just a matter of hooking the Brake Return Spring over the axle. I attached the extension spring to the deck bracket and used a small length of nylon rope that I tied a loop at one end. I slid the loop over the end of the extension spring and pulled it back till the extension spring hooked up to the Brake Return Spring. Just a matter of a few seconds. Without the missing part the belt squealed loudly because it wasn't pulled tight into the pulley on the PTO. After installing the parts the belt hooked up right away and I also noticed it maintained deck RPM even in tall grass. It used to stall before in tall grass before the missing part was installed.

Did you find this story helpful?

Thanks for voting and helping fellow customers!