This is a genuine Husqvarna fuel line that is commonly used on gas trimmers and blowers. It is supplied directly from original equiplement manufacturer. The fuel line delivers gasoline from the tank into the carburetor. These fuel lines are made out of clear flexible rubber material that over time may begin deteriorate and crack allowing for leaks. At this point it is time to replace the line. Includes one 25-inch fuel line.

The purpose of the 530069216 Tank Purge Line is to return the excess fuel that is in the carburetor after the primer bulb has been pushed.
The excess fuel is forced through the purge line back into the fuel tank.
Over time the Tank Purge Line will become brittle and crack and will need to be replaced.

This is a genuine OEM replacement part, it sold individually.
The primary purpose of this part is to attach the chainsaw bar to the models shown below.
There are two of these Bar Mounting Nuts used on the saws.

This part is also used on Husqvarna and Craftsman Chainsaws.

This is an OEM replacement part and is sold individually.
Its propose is to deliver an electric current from an ignition system to the combustion chamber of a gas fueled engine.
It will ignite the air fuel mixture by the spark.
Spark Plugs will usually have to gapped to the manufactures specifications found in the owners manual.

Over time a Spark Plug will become fouled because the air/fuel ratio may be set wrong,worn piston rings, carbon build up and other factors.
It is better to replace a fouled spark plug, rather then trying to clean it.

This is a genuine OEM replacement part, it is sold individually.
By pressing on the Purge Bulb, it will force fuel into the fuel line from the fuel tank into the carburetor.
Once the carburetor is full of fuel, the excess fuel will be purged back into the tank in the fuel return line.

Over time the primer will lose its elasticity or crack and need to be replaced.

We have an article and video on

This is a genuine OEM replacement part, it is sold individually.
The Fuel Filter is inside of the fuel tank.
Its purpose is to filter out dirt and other debris from contaminating the carburetor.

It will at sometime become clogged and restrict the fuel getting to the carburetor,and will have to be replaced.

We do have an article and video on How to Replace the Fuel Filters in Your Outdoor Power Equipment..

You can see this by going to the front page of our site and clicking on Repair Center.