This is a genuine Husqvarna fuel line that is commonly used on gas trimmers and blowers. It is supplied directly from original equiplement manufacturer. The fuel line delivers gasoline from the tank into the carburetor. These fuel lines are made out of clear flexible rubber material that over time may begin deteriorate and crack allowing for leaks. At this point it is time to replace the line. Includes one 25-inch fuel line.
The purpose of the 530069216 Tank Purge Line is to return the excess fuel that is in the carburetor after the primer bulb has been pushed.
The excess fuel is forced through the purge line back into the fuel tank.
Over time the Tank Purge Line will become brittle and crack and will need to be replaced.
This is a genuine OEM replacement part, it is sold individually.
The Fuel Filter is inside of the fuel tank.
Its purpose is to filter out dirt and other debris from contaminating the carburetor.
It will at sometime become clogged and restrict the fuel getting to the carburetor,and will have to be replaced.
We do have an article and video on How to Replace the Fuel Filters in Your Outdoor Power Equipment..
You can see this by going to the front page of our site and clicking on Repair Center.
This is an OEM replacement part sourced directly from the manufacturer. Sold individually. This no grease mandrel assembly includes housing, shaft assembly, bearing, and nut only - pulley/washer and blade bolt/washers are not included.
This is the part the mower blade attaches to, it is mounted to the deck of the mower by four bolts.
Spacer must be installed under the pulley.
Installing with the spacer on top of the pulley (or failing to use spacer) will result in damage to shaft and pulley.
The mounting holes on the Mandrel are not threaded. But the bolts that are used to secure the mandrel to the deck are self tapping. The Mandrel shaft goes thru the deck and the pulleys are attached to them, then the belt that drives the mandrels is placed in the pulleys.
Genuine Husqvarna replacement part, this item is sold individually.
This is a self threading screw that is most commonly used for securing the mandrel housing to the mower deck of the riding mowers listed below.