Authentic OEM sourced replacement part used on lawn mowers. This cable assembly consists of a metal wire cable with z-type bent ends, rubberized cover/body and a plastic clip. Blade control cable stops the blade when the control handle is released on walk-behind mowers. If the cable is broken it will cause the brake to not release even when the lever is pressed.

You may need pliers to complete this repair.

• First you want to see where tje old cable is attached to the motor assembly.
• Just remove the cable end there and install the new one,
• Now you can run the new cable up to the control handle
• Then just as the old cable, put the Z-shaped end through the hole in the control handle
• Once both ends are attached, just push the upper mount assembly of the old cable out of the hole in the upper handle
• Tie the cable in place just as the old one was, but leave enough clearance and free play to avoid over-bending and breaking the new cable

This is mulching blade is specially designed for use with Craftsman riding lawn mowers/tractors. Mulching blades are shaped to keep the grass under deck for longer allowing it to be cut into smaller pieces. This provides natural mulch for your lawn since smaller clippings will decompose quicker, releasing their nutrients into the soil. It is made out of metal and it is sold individually.

To install this mulch blade you would need a socket wrench.

• Park the riding lawnmower on a flat surface such as a garage floor or a driveway
• Disengage blades by pulling the cutting deck lever fully to the disengaged position
• Set the riding lawnmower cutting deck to the highest position to access blades
• Unscrew the blade bolt
• Remove old blade and secure a new one in place
• Reassemble in reverse order and test your new blade

This replacement front wheel and tire assembly is specially designed for use with Craftsman walk-behind lawn mowers. The purpose of a wheel is to allow mower to be mobile. This includes one (1) plastic wheel.

Replacing this wheel assembly is a simple task that should only require a wrench.

• First you want to remove the lock nut
• Remove old wheel and secure the new one
• Secure the lock nut

This is a genuine OEM sourced replacement part is used with walk behind lawn mowers. This is the drive wheel which has plastic gears on the inside. It is designed to be driven by a pinion gear which is sold separately. If the wheel is broken or damaged it should be replaced to ensure smooth ride and consistent cut of the grass. Includes one (1) plastic wheel.

This is an authentic OEM sourced replacement screw designed for use on Craftsman riding lawn mowers/tractors. This is a self threading screw that is most commonly used for securing the mandrel housing to the mower deck of the riding mowers. It is made out of metal and it is sold individually. Requires a wrench to secure of loosen this screw.