Roper
We sell only genuine Roper ® parts.
Popular Categories
Popular Parts
This is an authentic KitchenAid part. This screw is used on many bowl lift style KitchenAid mixers to secure the Bowl Spring Latch (Part number 3182857) into place. This screw is a slot headed screws that is made of steel. You can rest assured ordering this screw knowing that it has been made specifically KitchenAid mixers. This screw will correctly fit and retain the Bowl Spring.
This is a genuine component which is specially designed for use with Whirlpool washers. It is supplied directly from the original equipment manufacturer. This item provides a high-quality replacement for a missing or a faulty hardware that was installed on a new unit. The screw helps to secure the agitator. Please make sure to refer to the appropriate diagrams of your model for the correct application of this part. Keep in mind this high-quality item includes one durable metal screw and one washer. Replacing it is a simple task that should only require a small wrench.
This is a genuine OEM sourced part which is specially designed for Whirlpool dryers. It is an identical replacement for a missing or a damaged idler pulley assembly that was installed on a new unit. The purpose of this component is to apply tension on the belt that drives the drum. This high-quality assembly consists of a metal bracket and a plastic pulley. To perform this repair you will need a wrench set, a screwdriver, and pliers to take apart and reassemble the housing. Make sure to refer to the appropriate diagrams of your model for the correct location and installation of this part.
This is an original part from Whirlpool, Maytag, International, Jenn-Air, Crosley and Roper for use with Dryers. The support roller shaft attaches the support roller to the dryer and provides a place for the roller to rotate. The most common reason for replacing the roller shaft is if the bearing in roller went bad and gouged up the surface of the axle shaft. This part is sold individually. Here is a list of tools that are needed to replace the roller shaft are a Phillips screwdriver, 5/16” nut driver, snap ring pliers, flathead screwdriver, and 1/2” wrench. Unplug the dryer before installing this part.
This is a genuine OEM part. The door shelf end cap kit is made for use with many refrigerators. The Whirlpool kit includes two end caps, two adhesives and repair instructions. The end cap helps to hold the door shelve retainer to the door. This kit is sold individually. A screwdriver may be needed for making the replacement.
Join our VIP Email list
Receive money-saving advice and special discounts!
Thank you!
Error
