Angle Grinder Seal or Gasket | eReplacementParts

O-ring

$6.16

Minimum Quantity of 2 required

Manufacturer Part Number:: 213960-9

This O-ring creates a tight seal within the spindle lock assembly, helping prevent oil leaks while keeping dust and debris out of the gearbox. Made from durable rubber and measuring approximately 0.25 × 0.25 × 0.25 inches, it supports reliable protection and long-lasting performance. Replacing a worn or damaged O-ring helps maintain proper sealing, protect internal components, and ensure smooth tool operation.

O-ring

$6.16

Minimum Quantity of 2 required

Manufacturer Part Number:: 34-40-0450

This is a genuine manufacturer-sourced replacement o-ring which is specially designed for use with Milwaukee angle grinders. It is utilized to provide an air-tight seal between connected pieces, make sure to check appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

O-ring

$6.55

Minimum Quantity of 2 required

Manufacturer Part Number:: N355619

This part is sold individually. The o-ring goes on the guard and is made of rubber. A set of pliers and a screwdriver might be needed during the installation process. It may become broken and will need to be replaced. This part is an OEM from DeWALT for use in grinders.

O-ring

★★★★★

(5)

$6.09

Minimum Quantity of 2 required

Manufacturer Part Number:: 633043-00

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. Of the many causes for O-Ring failure, the most common are: Extrusion and Nibbling - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring,...

O-ring

★★★★★

(1)

$6.35

Minimum Quantity of 2 required

Manufacturer Part Number:: 633044-00

This is an authentic manufacturer sourced replacement part designed for use with Dewalt grinders. It helps to provide an air tight seal for the gearbox. It is made out of rubber material and it is sold individually. To complete this repair you will need a spanner wrench.

O-ring

$6.19

Minimum Quantity of 2 required

Manufacturer Part Number:: N263699

This authentic manufacturer-supplied washer is specially designed for use with DeWALT angle grinders. It is a special hardware that helps to provide a tight seal between connected components. This is an identical replacement for a missing or a damaged O-ring that was installed on a new unit. One durable rubber part is included. Refer to the appropriate diagrams for your model to ensure the proper ...

Seal

★★★★★

(1)

$10.02

Manufacturer Part Number:: 01464

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sold individually. Replacing this item you would need a wrench...