DeWALT Angle Grinder Seals and Gaskets

This is an authentic manufacturer sourced replacement part designed for use with Dewalt grinders. It helps to provide an air tight seal for the gearbox. It is made out of rubber material and it is sold individually. To complete this repair you will need a spanner wrench.

This part is sold individually. The o-ring goes on the guard and is made of rubber. A set of pliers and a screwdriver might be needed during the installation process. It may become broken and will need to be replaced. This part is an OEM from DeWALT for use in grinders.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. Of the many causes for O-Ring failure, the most common are: Extrusion and Nibbling - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring,...

This authentic manufacturer-supplied washer is specially designed for use with DeWALT angle grinders. It is a special hardware that helps to provide a tight seal between connected components. This is an identical replacement for a missing or a damaged O-ring that was installed on a new unit. One durable rubber part is included. Refer to the appropriate diagrams for your model to ensure the proper ...

It is a genuine manufacturer-sourced replacement part that is supplied for use with DeWALT and Black and Decker power tools. This is a special o-ring which is utilized to provide an air-tight seal between connected pieces, for the correct application make sure to check appropriate diagram of your model. Over time o-rings tend to deteriorate and crack eventually requiring a replacement to maintain ...

This is an authentic replacement part manufactured for use with angle grinders. O-rings can wear overtime, and should be replaced. This o-ring is used to seal the spindle lock, and is sold individually.

It is an authentic high quality replacement part that is specially manufactured by Dewalt for use with angle grinders and cut off tools. This gasket provides an air tight seal between the gear case cover and the gear case itself. Please note one durable rubber gasket is included per order.

Included in part number 398618-00

It is a genuine replacement hardware that is supplied directly from the original manufacturer for use with Dewalt angle grinders. This felt seal fits between the bearing and the bearing retainer, for correct application make sure to check appropriate diagrams of your model. Over time the seal may wear out and get compressed eventually requiring replacement to maintain peak performance. It is made ...

O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. Of the many causes for O-Ring failure, the most common among power tools are: • Extrusion and Nibbling - The O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off ti...

This is an original DeWALT replacement part. The O-ring is designed by the manufacturer for use in grinders and sanders. This part is made of flexible plastic, and is generally used to secure the connection with the gear case cover. Please be aware that there are different O-rings used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a screw...

This is an authentic replacement part sourced directly from the manufacturer. The O-ring is commonly found in power tools such as table saws, reciprocating saws, and impact wrenches from DeWALT and Black & Decker. This part is made of flexible rubber, and may be found in various locations in the machine, depending on model. Please be aware that there are different O-rings used in the machine. ...