Dynabrade Angle Grinder Seals and Gaskets

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sold individually. Replacing this item you would need a wrench...

This replacement o-ring is an original Dynabrade part that is specially produced for use with sanders, drills and grinders. It is an authentic OEM item that has multiple uses depending on your equipment, please make sure to check appropriate diagrams for correct location and use of this o-ring. Note one durable rubber o-ring is included per order.

It is a genuine replacement o-ring which is supplied by the original equipment manufacturer for use with Dynabrade power tools. This item is utilized to provide an air-tight seal between connected parts, please make sure to check appropriate diagram of your model for the correct use and location of this component. Over time o-rings tend to deteriorate and crack eventually requiring replacement to ...

This part is an OEM from Dynabrade. Compatible with a variety of power tools, this item is sold individually. The rubber o-ring often provides protection from friction and leakage. Please refer to the specific manual for repair instructions.

This is an authentic Dynabrade replacement part that has been sourced from the original manufacturer to be used with grinders and sanders. This item is used to provide spacing between the retainer and the spindle. This item is available as an individual replacement part.