Craftsman Trimmer Parts

Craftsman Appliance Parts

We sell only genuine OEM Craftsman ® parts.

Top Craftsman Trimmer Models

See All Models

Popular Craftsman Trimmer Parts

Manufacturer Part Number:
385022-03N
It is a genuine OEM supplied replacement part that is specially designed for use with Craftsman trimmers and edgers. The purpose of this cover is to secure the spool and line for the trimmer inside the cutter head assembly. To replace the part you simply press on the two upper tabs of the cover to release it from the spool housing. Please note this high quality plastic item is sold individually.
Manufacturer Part Number:
753-06183
This OEM fuel tank assembly is made out of Plastic and it includes the fuel lines, fuel cap, and fuel filter. It is a common part in gas trimmers that is used to hold the fuel needed for the engine. It is very important to replace the fuel tank if it is cracked or damaged to avoid further damage or serious injuries. Make sure to drain the gas tank before starting a repair.
SPRING, SPOOL COVER
★★★★★
★★★★★
(19)
$5.16
In Stock
Minimum Quantity of 2 required
Manufacturer Part Number:
90566944
Genuine Black and Decker replacement part, this item is sold individually. The purpose of the 90566944 Spring is to hold the spool in place on the Trimmer shown below. It is placed between the spool and the spool cover. The cover snaps into the spool housing by means of the two tabs on both sides of the cover.
Manufacturer Part Number:
530150253
This is a genuine Husqvarna replacement part, it is sold individually. The purpose of this filter is to keep dirt and other small particles from entering the carburetor and engine and causing internal engine damage. Once this type of filter gets clogged or dirty it should be changed (Not Cleaned). This is to prevent restricted air flow and foreign matter from entering the engine.
Manufacturer Part Number:
530069599
This is a genuine OEM replacement part designed for use with gas trimmers/blowers. The fuel line is what delivers the fuel from the fuel tank into the carburetor. When you press the primer bulb, it will purge all the air out of the carburetor and fill its chambers with fuel. The excess fuel is then forced back into the tank through the return line. Over time these lines will become brittle and may...
Manufacturer Part Number:
503235111
Genuine OEM replacement part used with some Husqvarna Power Equipment. This item is sold individually. A spark plug is used to deliver electric current from an ignition system to an internal combustion engine. After time spark plugs will become dirty or fouled. It is a good idea to replace the spark plug once this happens. You should gap your spark plug according to the owners manual of the outdoor product you have.
Manufacturer Part Number:
90567077
This is a genuine Black and Decker replacement part, it is sold individually. The purpose of the 90567077 Lever Assembly, is to regulate the amount of line that is fed from the auto-feed spool. This part has a tendency to wear out often. It is advised to have an extra one on hand.
Manufacturer Part Number:
753-06190
A carburetor basically consists of an open pipe through which the air passes into the inlet manifold of the engine. The pipe is in the form of a Venturi: it narrows in section and then widens again, causing the airflow to increase in speed in the narrowest part. Below the Venturi is a butterfly valve called the throttle valve ' a rotating disc that can be turned end-on to the airflow, so as to h...
Manufacturer Part Number:
530069247
This is the replacement fuel line 25 Inch for several OPE products that use small engines. The fuel line carries fuel from the tank to the carburetor. Over time, the fuel line can become badly clogged, and it can become brittle as well. When the fuel line is badly clogged or cracked, fuel can leak out and it can make it difficult to start or run the engine. To replace the fuel line, carefully disc...
Manufacturer Part Number:
530095646
This Genuine OEM fuel filter is designed to maintain the performance and longevity of your equipment by preventing dirt and debris from entering the carburetor. Located inside the fuel tank, this essential component ensures clean fuel delivery, protecting the engine from potential damage caused by contaminants. Sold individually, the filter is built to meet original equipment standards for fit and...
Manufacturer Part Number:
530069216
This is the Genuine Craftsman replacement part. It is made out of Flexible Rubber and is Sold Individually. The purpose of the 530069216 Tank Purge Line is to return the excess fuel that is in the carburetor after the primer bulb has been pushed. The excess fuel is forced through the purge line back into the fuel tank. Over time the Tank Purge Line will become brittle and crack and will need to be replaced.
Manufacturer Part Number:
N498091
This is a Genuine OEM Sourced replacement part designed for Black and Decker String Trimmer. This item is used to secure and drive the Spool. It is made out of Plastic and Metal. Includes a Plastic Housing, Plastic Gear, Metal Bearing and Two (2) Metal Eyelets.

Craftsman Trimmer Models

Shop by Popular Craftsman Trimmer Part Types