Tiller Hoses and Tubes
Popular Tiller Hoses and Tubes Parts
- Manufacturer Part Number:
- A203641
This item is an authentic OEM sourced part that is intended to be used with cultivators from Southland and Powermate. This item includes the fuel pick and return lines, the grommet, and the fuel filter. This part kit is sold complete including all the items that are photographed, but it is priced as a single item.
- Manufacturer Part Number:
- 791-683974B
This is a genuine OEM approved replacement part, it is specially designed for use with Craftsman gas powered lawn and garden equipment. By pressing on the purge bulb, it will force fuel into the fuel line from the fuel tank into the carburetor. Once the carburetor is full of fuel, the excess fuel will be purged back into the tank in the fuel return line. Over time the material may begin to deterio...
- Manufacturer Part Number:
- 791-682039
The 791-682039 Fuel Filter and Line, filters the fuel in the tank as it is forced into the carburetor up by means of the primer bulb. To install. Remove retainer ring from fuel line. Insert fuel line thru gas cap opening. Thread fuel line thru hole in bottom of the fuel tank. Pull fuel line thru to firmly seat against inside tank wall. Put retainer ring on fuel line,hold line and press ring firml...
- Manufacturer Part Number:
- 791-181086
This fuel line is an original part from Craftsman for trimmers, blowers, edgers and cultivators. This part is supplying gas, starting with the tank to the carburetor. You will need a screw driver, pliers, a hose pulling wire and cutters to replace this part. This fuel line is made of rubber and sold individually.
- Manufacturer Part Number:
- 17504-ZM3-003
This is an OEM Honda part manufactured for use with small engines. This rubber grommet is used to provide a seal to allow fuel lines to pass into and out of the fuel tank without leaking. Overtime fuel can deteriorate the grommet, so replacing it can ensure a good seal. The grommet is sold individually, please see model diagram for additional parts.
- Manufacturer Part Number:
- 791-182352
The purpose of the 791-182352 Fuel Return Tube is to return the excess fuel back into the fuel tank, after the primer bulb has been pressed and has primed the carburetor to start. Over time the Fuel Return Line will become brittle and crack and will need to be replaced.
- Manufacturer Part Number:
- A101191
This is a genuine replacement part that has been sourced from the original manufacturer to be used with blowers and edgers from Powermate and Southland. The plastic fuel fitting is used to couple portions of the fuel line between the tank and the carburetor. This fitting is also used as a filter to prevent contaminants from entering the fuel intake. This fuel line fitting is sold as an individual replacement part.
- Manufacturer Part Number:
- 731-07059
The breather hose acts as a valve for the fuel tank, it allows for the air to enter the fuel tank but it won\\\'t allow fuel or fuel emissions to leave the tank. It is an identical replacement for a worn, damaged or a missing component that was installed on a new unit. This is a genuine OEM sourced replacement part which is designed for use with a variety of lawn and garden equipment. It is made o...
- Manufacturer Part Number:
- 13201049030
This replacement fuel pipe is a genuine OEM item, it is specially produced for use with Echo and Little Wonder gas powered equipment. This is only the return pipe, note that the supply pipe is sold separately. By pressing the primer bulb it will fill the carburetor with fuel, once it is full the excess fuel will be forced back into the tank through the fuel return line. Over time the material may ...
- Manufacturer Part Number:
- 921-04041
This special item is attached to the deck allowing a garden hose to be connected to clean under the deck. It is an identical replacement for a damaged or a missing hardware that was included with a new equipment. Keep in mind this high-quality part is made of durable plastic and is sold as an individual item. It is a genuine OEM supplied water nozzle adaptor which is made for riding lawn mowers and garden tractors.