Craftsman Tiller Hoses and Tubes

This is a genuine OEM approved replacement part, it is specially designed for use with Craftsman gas powered lawn and garden equipment. By pressing on the purge bulb, it will force fuel into the fuel line from the fuel tank into the carburetor. Once the carburetor is full of fuel, the excess fuel will be purged back into the tank in the fuel return line. Over time the material may begin to deterio...

The 791-682039 Fuel Filter and Line, filters the fuel in the tank as it is forced into the carburetor up by means of the primer bulb. To install. Remove retainer ring from fuel line. Insert fuel line thru gas cap opening. Thread fuel line thru hole in bottom of the fuel tank. Pull fuel line thru to firmly seat against inside tank wall. Put retainer ring on fuel line,hold line and press ring firml...

This fuel line is an original part from Craftsman for trimmers, blowers, edgers and cultivators. This part is supplying gas, starting with the tank to the carburetor. You will need a screw driver, pliers, a hose pulling wire and cutters to replace this part. This fuel line is made of rubber and sold individually.

The purpose of the 791-182352 Fuel Return Tube is to return the excess fuel back into the fuel tank, after the primer bulb has been pressed and has primed the carburetor to start. Over time the Fuel Return Line will become brittle and crack and will need to be replaced.

The breather hose acts as a valve for the fuel tank, it allows for the air to enter the fuel tank but it won\\\'t allow fuel or fuel emissions to leave the tank. It is an identical replacement for a worn, damaged or a missing component that was installed on a new unit. This is a genuine OEM sourced replacement part which is designed for use with a variety of lawn and garden equipment. It is made o...

This is a genuine OEM sourced component which is specially designed for use with lawn and garden equipment. It is an identical replacement for a missing or a faulty nipple that connects the fuel hose, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality nipple is made of durable plastic and is sold individually.

This is an original replacement part manufactured for use with small engines. This special fuel fitting is used to connect the fuel line to the carburetor. Overtime old fuel can clog passageways within the carburetor and may require the carburetor to be rebuilt. This fuel fitting is sold as an individual replacement part, please see model diagram for associative parts.

This is an authentic MTD replacement part. The fuel line kit is designed by the manufacturer for use in snowblowers. This part includes the rubber tube and two metal clamps, and is used to carry fuel through the machine. You will require pliers when replacing these items.