Part Location Diagram of 10CJ2 Shimano Drag Washer
See part 3915 in the diagram
( Grid squares measure 1x1 inch )

Drag Washer 10CJ2

Manufactured by:
Shimano
ERP Number:
ERP18251164
Part Number:
10CJ2
Original Equipment Manufacturer ?
$5.95
Special Order
Minimum Quantity of 2 required

Easy 

30 - 60 mins 

(2 rated repairs) ?

Does this part fit my model?

Need help finding your model number?

Troubleshooting

This part works with the following brands:
  • Shimano
This part works with the following products:
  • Baitcast Reels

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

30 - 60 mins 

(2 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Fishing reel drag did not tighten, low drag strenght.

Thomas from Pendleton, Oregon

3 of 3 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers, Wrench set
Parts Used:
10D60, 10CJ2, 1071W
I disassembled the reel and laid each piece out in the order they came off the reel. The work was done over a large towel laid on the work surface to prevent a dropped part from bouncing off the table to the floor. Each part and the reel case was cleaned with cotton swabs and rubbing alcohol and oiled with Shimano brand oil and drag greas e. The reel was re-assembled in the correct order and part orientation. Some parts could be placed back in the reel in the wrong orientation(upside down) so be sure to note this when you pull them out of the reel.
It is very helpful to have a schematic of your reel at hand for reference when you put the reel back together.
The reel now works as it did new.
Did you find this story helpful?
Thank you for voting!

Bearings rusted and frozen

Wesley from Corpus Christi, Texas

1 person found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Screw drivers
Parts Used:
10F66, 10EX8, 10CJ2, 1071W, 105C3
Open the side of reel and cleaned. Removed damaged parts and replaced with new.
Did you find this story helpful?
Thank you for voting!
  • 1