This is a genuine Husqvarna replacement part, it is sold individually. The purpose of this filter is to keep dirt and other small particles from entering the carburetor and engine and causing internal engine damage. Once this type of filter gets clogged or dirty it should be changed (Not Cleaned). This is to prevent restricted air flow and foreign matter from entering the engine.
Used a nut driver to remove the old carburetor assembly. Removed and re-attached fuel lines to the new carburetor in the same way they were previously attached. Installed the new carburetor assembly with new gaskets. Removed and re-installed the in-tank fuel filter and installed the new air filter. The blower started right up and the H
... Read morei and Low speed needles and idle speed were adjusted using a 21 spline carburetor adjusting tool and phillips screw driver. The parts arrived earlier than expected and were exactly what I needed to get my blower going. I\'ll use eReplacementParts again. Thanks.
Read less
Did you find this story helpful?
Thank you for voting!
Gas line had a hole in it and the primer bulb was hard.
1. Removed and replaced the old fuel line and primer bulb.
2. Replaced the spark plug.
3. Added a new fuel filter.
No hassles with the wrong size or length of the fuel line. Was extremely east to complete.
Remove housing cover. Remove air filter and cowling. Remove cab assy & replace with new assy. Reassemble air filter housing and install new filter. Replace outer housing cover.
Fill fuel tank, prime & start engine.
Do the happy dance!!!
1.Removed pull start
2. Removed side housing under pull start
3. Remove air cleaner front and air filter
4. Remove carburetor nuts
5. Disconnect primer ball from air cleaner housing .
6. Remove old fuel tank from blower and carburetor being careful not to damage carb gaskets.
7. Pull old fuel lines
... Read moreoff with pliers and push new ones on from new tank assembly.
8. Reassemble blower in reverse order and a new air filter should be installed at this time.
I keep extra air filters at the house, but this machine, I had run out. I cleaned the filter with choke cleaner and it operated okay. I ordered two new air filters so as not to have trouble again. All you need to do is remove the air filter cover and remove the old air filter, then replace it with the new one. Then replace the cover.
... Read more />This company has the best prices of most companies and original factory specs. The service they provided to me was some of the best services in quite some time. I will be ordering for my other equipment, air filters and plugs too.
Thank you so much for the great job!!!
In the course of replacing the filters (easy repair) I noticed dirt and debris in and around the carburetor. I decided to remove the blower housing to gain access to the carburetor. I carefully removed the carburetor making sure not to damage the gaskets.
Using a carburetor cleaner I sprayed the unit and it easily removed th
... Read moree gunk and dirt that had built up. The cleaned carburetor with new filters and spark-plug work great. The motor is running with more power.
If you do this repair there are some great videos on YouTube that I found extremely helpful.
Read less
Did you find this story helpful?
Thank you for voting!
Filter needed replacement to ensure proper running of machine
Leaf Blower / Vacuum
- Husqvarna Leaf Blower Model HVA125BX Parts
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
