This is an authentic Husqvarna replacement part manufactured for use with handheld leaf blowers. This gasket is a set that includes the muffler gasket, carburetor gasket, intake gasket, and the crankshaft seals. It is recommended to replace gaskets when servicing an engine to assure a good seal when the parts are reassembled. This gasket set is sold individually.
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
A Bit Difficult
1- 2 hours
(4 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Engine would not start, after diagnosis, it was determined that there was a loss of compression. I did a complete engine disassembly and found the piston ring was seized.
After disassembly of the engine, I removed the old piston and replaced it with the new one. I made sure it was oriented exactly as the old piston had been (be sure to make note of the proper orientation during disassembly). I carefully put the ring around the groove in the piston and lubricated all parts with 2 cycle engine oil. I inser
... Read moreted the piston back into the cylinder (also lubricated) and reassembled the blower insuring to use all new gaskets and seals to prevent leakes. (Note: I used a business card to get the proper gap between the magnets and ignition coil during reassembly.) After it was reassembled, it started on the fourth pull.
Had I brought the blower to a repair facility it would have cost nearly as much to repair as a new blower. I was able to repair this one as good as new for just over $40.00 and some time invested.
Disassembled complete blower. Removed cylinder, piston / ring assy from connecting rod, honed cylinder. Replaced piston, ring, and gaskets. Reassembled blower. Compression up to 140 psi. Started on second pull. This is a husqvarna 125b blower.
Removed the piston and bottom crank case cover. Replaced piston ring which was broken.
Also replaced crankshaft seals. Replaced crankcase bottom seals.
Did you find this story helpful?
Thank you for voting!
Blower lost compression and would not run
Jason from CAMERON, North Carolina
0 of 1 peoplefound this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
Leaf Blower / Vacuum
- Husqvarna Leaf Blower Model HVA125BX Parts
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
