It is a genuine manufacturer-sourced replacement part that is specially designed for use with Craftsman chainsaws. The purpose of an air filter is to ensure that the air which is supplied into the unit is free of dust and other harmful contaminants, over time the material will get clogged eventually requiring a replacement to ensure the proper airflow. Please note this high-quality component is sold individually.
Loosen the tension on the blade. Remove the clutch cover. Then remove the bar and chain. Remove the e-ring and washer and the clutch drum. Now you have to lock up the engine for the removal of the clutch. To do this, remove the spark plug and place a length of rope into the cylinder, with some of the rope left out of the cylinder. Turn th
... Read moree clutch until the piston comes in contact with the rope and stops moving. With a screwdriver and hammer, strike the edge of the clutch in a clockwise motion until it is loose on the shaft. Remove the old clutch , then install the new clutch, tapping it with the hammer and screwdriver in a counterclockwise motion. Start replacing all of the parts that were removed from the saw ion reverse order. And don\'t forget about the spark plug. For the filter, simply remove the filter cover and remove the old filter and replace it with the new one, then replace the cover.
Read less
Did you find this story helpful?
Thank you for voting!
Connection from flywheel magnet to spark plugs, the metal pieces touching the flywheel had broken.
Removed all outer casing.
Removed the wires from the start/stop switch assembly.
Loosened the wires from the clip attached to the main body.
Unscrewed the black box for the ignition module.
Removed all wires, pieces, etc.
Attached the new ignition module and screwed in.
Fed wires up to start/stop swit
... Read morech and reattached.
Reconnected to the spark plug.
Reassembled outer casings.
Started chainsaw as normal.
Note that when reattaching the black wire to the start stop switch, use a flathead screwdriver to gently move the metal connector plate nearest to the red switch back, then insert the end into the opening and release the metal plate.
Read less
Did you find this story helpful?
Thank you for voting!
All of the fuel lines was broken due to me leaving fuel in the tank of the winter months.
I removed the plastic covers on the top and side of the chain saw to replace the fuel lines to the carburetor and primer bulb. I also removed the fuel cap and drained the fuel from the tank to connect the fuel line in the tank and replace the assy-pick-up and fuel line fitting.
1. Took off the air cleaner cover.
2. Took off the pull rope cover.
3. Took off the coil.
4. Took off the stator.
5. Did everything in reverse.
6. Used a .014 shim between the coil and the stator to set the gap.
7. Put in the new air filter.
8. Put the covers back on.
9. One pull full choke
... Read more.
10. One pull half choke.
11. Runs like new.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
