This genuine manufacturer-sourced part is specially designed for use with Campbell Hausfeld and Ridgid air compressors. The purpose of a pressure switch is to control when the compressor should start and stop building up pressure. There are several reasons it could be leaking air, unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Note, this pressure switch cuts in at 120psi and cuts out at 150psi. Keep in mind this high-quality part is sold individually, Please refer to the appropriate diagrams of your model for the correct location and application of this pressure switch.
Troubleshooting
This part works with the following brands:
Campbell Hausfeld
Ridgid
This part works with the following products:
Compressor
★
Customer Part Reviews
?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(2 Reviews)
Click to filter by ratings:
5 stars
2
4 stars
0
3 stars
0
2 stars
0
1 star
0
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Honest, it works better than new
The pressure switch arrived but internally was different but all the piping was correct. After installation I crossed my fingers it was correct. It pumped up to 160 pounds and shut off. I was never able to control the output on the secondary now it' perfect.
Guest - November 5, 2020
Verified Purchase
★★★★★
★★★★★
Fit just fine
The part was great Just what we needed.
Timothy - September 27, 2023
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Very easy.
Remove old parts.
Wrap threads with tape.
Install new parts.
Set regulator for desired cutoff psi. (they put wax over screw, remove wax and fill tank to desired psi and turn screw to the left until you hear \"click\". Regulator psi now set.)
Did you find this story helpful?
Thank you for voting!
Compressor would not stop adding air reaching a point of popping pressure valve
Removed the parts that did not come with the new pressure switch. Open the cover, made a wiring diagram, and disconnected the wires, then removed the old switch. Installed the new switch. Connected the wires. Put on all of the parts that were removed from the old switch.
The compressor work like new again
Did you find this story helpful?
Thank you for voting!
Pressure switch stuck
Peter from OCEAN SHORES, Washington
0 of 1 peoplefound this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set, Wrench (Adjustable), Wrench set
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of CW211300AV Campbell Hausfeld Pressure Switch")
_WW_1.gif "Part Location Diagram of CW211300AV Campbell Hausfeld Pressure Switch")
