It is a genuine OEM part that is made for Campbell Hausfeld air compressors. The unloader valve is an important component which allows a user to safely drain the air from the tank. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement to ensure your unit operates properly. Note, this high-quality unloader includes multiple parts however it is sold as an individual component. Check the owner\\\'s manual and the diagrams of your model to ensure the correct installation and application. You will need a wrench set and pliers to perform this repair.
Troubleshooting
This part works with the following brands:
Campbell Hausfeld
Husky
This part works with the following products:
Compressor
Part# CW210001AV replaces these:
CW210001AV,
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
1. Removed the small bolt that holds the unloader to the back side of the switch.
Note: You have to be careful when removing the unloader. There is a rubber o-ring type seal that comes out when you remove the unloader. Mine fell out on the floor and I couldn\'t tell which way the seal goes into the unloader as the seal is different
... Read moreon both ends. If not put in properly it could leak again. I guessed and was successful. You get a new rubber seal in the package with the new unloader.
2. Pulled the plastic tube off the unloader.
3. Put the plastic tube back onto the unloader.
4. Installed the rubber o-ring seal.
5. Put the unloader back into the backside of the switch and fastened the small bolt.
Read less
Did you find this story helpful?
Thank you for voting!
Air leaking while compressor was running take long time to build pressure.
Very easy.
Remove old parts.
Wrap threads with tape.
Install new parts.
Set regulator for desired cutoff psi. (they put wax over screw, remove wax and fill tank to desired psi and turn screw to the left until you hear \"click\". Regulator psi now set.)
Simply threaded in the new unloaded and threaded in the new nipple. Then pushed the tube into each end. Turned the compressor on and watched it build pressure and shut off.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of CW210001AV Campbell Hausfeld Unloader")
_WW_1.gif "Part Location Diagram of CW210001AV Campbell Hausfeld Unloader")
