This is a genuine Presto replacement part, it is sold individually. The purpose of the 09905 Pressure Cooker Canner Sealing Ring/Overpressure Safety Plug Pack is two-fold. The sealing ring is used to create a seal between the Pressure cooker lid and the pressure cooker pot. In the event if the pressure regulator fails, and to much pressure builds up in the pot, the Overpressure Plug will pop out of the lid releasing the excess pressure in the pot.
Remove the old sealing ring from the lid and clean out the slot where the seal fits into. Insert the new sealing ring in the lid. The from the back of the lid, pop out the old pressure plug and press in the new one. Then simply install the new regulator and steam gauge.
Did you find this story helpful?
Thank you for voting!
Canner and pressure cooker had dried/old rubber parts
THESE WEREN\'T FOR A RICE COOKER!!!!! They were for a pressure canner and a daily use pressure cooker!
Just remover hardened rubber parts and replaced. Then also replaced pressure gauge on canner and both got new gaskets. Very easy repairs. Bought extra rubber gaskets to have on hand because can\'t find them close to me. Jus
... Read moret used screw driver and pliers. Parts were easily switched just had to make sure new pressure gauge was good and tight.
First clean out space where sealing ring is placed. Install sealing ring and safety plug. Also replaced pressure regulator, the one we had was getting old.
Did you find this story helpful?
Thank you for voting!
Pressure gauge was broken, and sealing rings were old and leaky
First of all, I did not have a rice cooker, but a Presto pressure canner, and a Presto pressure cooker
Took out old pressure gauge from pressure canner
inserted new gasket into hole. This took a few minutes, and a little maneuvering, but it is supposed to be tight.
Screwed new pressure gauge into gasket. that\'s it. wor
... Read moreks great, doesn\'t leak.
Took out old sealing ring from pressure canner and put in new. Took out old vent plug and inserted new, required a little scrunching, but easy. Works great, doesn\'t leak.
This whole process (ordering, quick service, and replacing parts) was super easy, and so much cheaper than buying new equipment. My old pressure cooker and pressure canner are older, and heavier models, so I have better quality equipment than if I bought new.
Gifted an old Presto pressure canner. NOT a GÇÿrice cookerGÇÖGǪ..
Replaced the pressure gauge, overpressure plug, rubber lid ring, and a missing canning rack. Now I have a complete functioning canner!
Read instructions in booklet that came with my pressure cooker canner. Removed the old pressure gage, installed the new one following the instructions in the booklet.
My pressure cooker canner needed repair. It was not a rice cooker.
Replaced the pressure gage with the new one according to the directions in the booklet.
... Read more />Removed the old rubber gasket and replaced with the new gasket.
Remove and replaced the small rubber gasket in the top of the pressure cooker canner according to the instructions in the booklet that came with the canner.
Easy process. Thanks.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
