Drag Spring Washer 10D60

I disassembled the reel and laid each piece out in the order they came off the reel. The work was done over a large towel laid on the work surface to prevent a dropped part from bouncing off the table to the floor. Each part and the reel case was cleaned with cotton swabs and rubbing alcohol and oiled with Shimano brand oil and drag greas ... Read more e. The reel was re-assembled in the correct order and part orientation. Some parts could be placed back in the reel in the wrong orientation(upside down) so be sure to note this when you pull them out of the reel.
It is very helpful to have a schematic of your reel at hand for reference when you put the reel back together.
The reel now works as it did new.

Removed handle
Removed washer and Star drags
Replace two new drag washers
Reassemble parts

replaced parts, cleaned and lubricated

Remove handle and slide spring and washers off shaft and replace. Simple fix

Removed handle and side plate to expose the parts that were worn. Removed drive gear and drag assembly. Removed idler gear and level wind shaft. Installed new parts and reversed the sequence.