This is a genuine Murray replacement part, it is sold individually. It is commonly used in lawn tractors, and is used in various places in the compatible models listed below. It is self tapping, with a 9/16 hex head. Made of metal.

This is a genuine Murray Wing Knob used on the variety of Lawn and Garden equipment and is sold individually. This part is made out of durable Black Plastic. To ensure safe operation of equipment it is recommended to replace this Knob if original part has cracked or is broken.

This genuine OEM sourced replacement part is designed for use with Murray lawn mowers/tractors. This item engages and routes the battery electrical supply to the engine starter when the ignition switch is rotated to the start position. This solenoid is sold individually.

This is a genuine Murray replacement part, it is sold individually.
The Jackshaft housing is connected to the drive shaft, which is connected to the pulley driven by the belts and engine.
Below the Jackshaft Housing, the blade adapter, blade, washers and blade nut are attached to the drive shaft.
The Jackshaft Housing does include the bearing and a zerk fitting.

Genuine OEM replacement part, this part is sold individually.
This is the Side Discharge Chute for the lawn mowers listed below.
It is mounted to the side of the mower for the cut grass to be expelled out of it.
You also have the option of using part number 987-02516A Mulch Plug Assembly if you want to mulch your grass.

This genuine OEM replacement part is used on walk behind/push mowers. This cable consists of a metal wire cable with z-type bent ends and rubberized cover/body. The control cable stops the blade when the control handle is released on walk-behind mowers. If the cable is broken it will cause the brake to not release even when the lever is pressed.

You may need pliers to complete this repair.

• First you want to see where tje old cable is attached to the motor assembly.
• Just remove the cable end there and install the new one,
• Now you can run the new cable up to the control handle
• Then just as the old cable, put the z-shaped end through the hole in the control handle
• Once both ends are attached, just push the upper mount assembly of the old cable out of the hole in the upper handle
• Tie the cable in place just as the old one was, but leave enough clearance and free play to avoid over-bending and breaking the new cable