Search By Model Number
The 031014-104-000 Agitator is sold individually. The Agitator Assembly (Or Blade Assembly) is the part of the blender that chops, blends or mixes the product that is put into the blender jar. After time the blades will become dull or break or the spline that is attached to the shaft may wear out. When replacing the Agitator it is advisable to inspect the Sealing Ring, which is in between the agitator and the jar for cracks and if it has been compressed too much, which will cause it to leak from the bottom.
This is a genuine Oster/Sunbeam replacement part.
Only one is needed in this unit.
Depending on how frequently the blender is used. The Sealing Ring can become brittle and cracked or compressed so that it will not create sufficient seal to keep the contents of the jar from leaking out of the bottom. If you use your blender often, it may be a good idea to order more than one at a time, so you won't have any down time with your blender.
This is an original Oster replacement part. Because it has plastic threads they will wear at times and the jar will leak. Once you have this off, this is a good time to check the sealing ring to see if it is not cracked or if it has been compressed too much.
The purpose of this item is to hold the blade and seal in place at the bottom of the blender jar
Over tightening may crack this part, dropping it may break it and excessive heat may warp it.
Because it has plastic threads they will wear at times and the jar will leak.
Once you have this off, this is a good time to check the sealing ring to see if it is not cracked or if it has been compressed too much.
This is a genuine Oster replacement part, it is sold individually.
The Filler-Cap is used as a cap for the blender.
It can also be removed from the blender jar cover for the purpose of putting small food items in the blender without removing the entire jar lid.
This is a genuine KitchenAid replacement part, it is sold individually.
The coupling is the part of a blender that transfers power from the blender's motor to the blade assembly.
Over time, the teeth on blender coupling wear down until they no longer engage properly on the blade assembly.
We do have an article and video on "How to Replace the Coupling on a KitchenAid Blender" on our site. Go to the main page of our site and click on "Repair Center". Then type in the above article, and soon your Blender will be working like new.
Browse Blender Parts
Blender Repair Videos
Blender Repair Articles
|Quick Fix: How to Replace the Mantles on a Coleman Lantern|
|Learn how to easily replace the worn out mantles on your Coleman lantern....||If your lantern is no longer holding pressure in the tank then it is likely that the pump has become worn and will need ...|