Blender Hardware

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. For proper application please refer to diagrams of your unit. This part is made out of metal and it is sold individually.

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then wil...

This washer is a genuine OEM replacement part sourced directly from the manufacturer. It is commonly used in Waring blenders. This part is a small flat ring that is placed in-between the bearing holder and the bearing cap to evenly distribute the pressure. It should be replaced if any leakage occurs. It is sold individually and requires a wrench to replace.

This square drive coupling is an authentic Waring replacement part manufactured for use with blenders. The metal coupling is part of the drive coupling assembly that fits onto the motor shaft. This square coupling is the upper most part of the drive coupling that is inserted into the shaft on the blade assembly. The whole drive coupling is available separately, this part of the drive coupling asse...

Sold individually.

This is a genuine OEM replacement part used with many blending appliances. The Waring square drive stud is constructed of durable plastic, and is fitted in the drive coupling. This item helps to secure the jar to the blender motor. The square drive stud is sold individually. A screwdriver is needed for the proper installation.